Band-It tape, Type 316

Band-It - assembly example:
step 1: Pull the buckle with ears to the tape end on the tape. Form clamps and place tape on tape. Pull the buckle over both tapes and bend the tape end approx. 30 mm under the buckle. When there are high loads on the clamps (e.g. for hose assembly) pull the tape twice through the buckle.
step 2: Insert tape in the clamping tool from the side, press on the cam lever and tighten the crank clamps by rotating them. The maximum tension is reached when the tape can no longer be pulled under the buckle (this is easily "fulfilled" by applying a finger).
step 3: After reaching the required tension, bend the tool slowly over the buckle. At the same time, loosen the crank by approx. a half rotation in order to prevent loss of tension and cracks in the tape. In order to crop the tape, pull the cutting lever backwards.
step 4: Hit the tape onto the buckle with the hammer and fold both buckle ears over to secure the tape end.
Application: for all applications where high corrosion resistance is required
Assembly tool: C001, C003
Roll length: 30.5 m
Materials: rust-free stainless steel AISI 316 (1.4401) with fully rounded edges and high corrosion resistance
*packing unit: 100 pieces
Catalogue page Pneumatic Atlas 8 (Page 356) Catalogue page Pneumatic Atlas 8 (Page 1040) Suitable accessories:

Band-It assembly tool

All technical data are to be understood as non-binding reference values. prices given plus VAT
Click here in order to show prices with VAT included.